 |
| Powered by phpBay Pro |
I cant get any spark on my Honda CR85R?
At the risk of sounding like an idiot, I need some help. I have weak to no spark going to the spark plug so naturally it wont start. I have a 12 volt light tester so i unplugged the wire coming out of the stator and kicked it over and it lit up nice. I then checked the wire coming out of the CDI to the Ht coil and it lit up again, just not as brightly. I then put the light on the spark plug wire coming out of the Ht coil and nothing. So I bought a new HT coil, installed it and nothing again. I even eliminated the spark plug wire and boot by removing them and checking directly at the outlet of the coil. I checked the resistance according to the shop manual and it ohms out fine. I ground down the frame where the HT coil mounts and also checked the stop button. It seems like it has to be the HT coil but I hear they rarely go out and this one is brand new and I get the same readings on it as my old one. Any ideas? thanks
Here are my observations:
your old Ht coil is fine.
Your old CDI unit is fine too, based on what you say.
Try the conductivity for the engine kill switch and related wiring, i think this is what is meddling with the spark.
Finally, the rading drops after the CDI, so check whther that happens in a alternate CDI too.
If not you have to get a new CDI.
|
 AEMC 213519 4620 Kit 150 ft 4 Point Ground Resistance Testers  US $1,494.00
|
 Amprobe Ground Resistance and Resistivity Tester NEW US $1,479.99
|
 AEMC 3731 Ground Resistance Tester Clamp On 211761 US $1,462.50
|
 MASTECH MS2301 Clamp On Ground Earth Resistance Tester US $1,099.00
|
 AEMC CLAMP ON GROUND RESISTANCE TESTER MODEL 3731 US $1,299.00
|
 AEMC 4620 Ground Resistance Tester Digital 4 Point 213043 US $1,095.00
|
 ROD L M25 GROUND RESISTANCE CONTINUITY TESTER FULLY TESTED WORKING PROPERLY US $495.00
|
 EXTECH 382356 GROUND RESISTANCE CLAMP ON TESTER US $490.00
|
| Powered by phpBay Pro |