![]() |
| Powered by phpBay Pro |

DIY Electrical Projects And Safety Tips
Everyone likes to save money by performing do it yourself projects. Hiring an electrician to come and do a task for you can be very costly, so a lot of people attempt to do their own electrical work.
A professional should always do any major wiring projects, but there are a few minor projects you could do yourself. Even though they’re minor tasks, there’s still danger of electrical shock involved with them.
While getting shocked is a prime concern with electrical projects, an electrical fire can also be involved if you don’t take special precautions to protect yourself and your home.
Here are some tips on how to stay safe the next time you work around wiring:
Always make sure that you cut off the power to the area you’ll be working on. Don’t rely on just the power switch being off. Go to your fuse box and either remove the appropriate fuse or flip the right switch to cut the power off completely.
Alert anyone in the house what you’re planning to do (and keep children away from the work in progress). It would also be a good idea to place tape over the circuit switch in case someone else comes along who doesn’t know what’s going and tried to turn the circuit back on.
When you begin to work on the area, you should always treat it as if it were still a live wire. Work slowly and take your time doing the work. You should be free from any distractions. There’s no room for mistakes, so don’t try to hurry through the project just to get it done.
Use a fiberglass ladder if you need one because they’re non-conductive ladders and will absorb any electric shocks that may come through. Wear heavy rubber soled shoes as well to help absorb as much of the electric shock as possible should one occur.
Use a power tester to test the wires you’ll be working on. Make sure there’s no power going through the wire. It’s possible that you could have hit the wrong switch on the fuse box, so take that extra precaution and test the wire before working on it.
Don’t work in damp, wet areas. Electricity and water do not mix! Try to dry the area first before performing any projects with electricity. You should do this with any damp areas that are close by where you’ll be working - even if they aren’t in the precise vicinity.
Be carefull when doing a roof repair to make sure not any electrwire overhead. The simplest roofing repair can go very wrong if anyone comes in contact with a live overhead wire
Make sure you know what you’re doing before you do it. Taping the wrong wires together can result in a major electrical fire when the electricity is turned back on. Do it correctly the first time and you can avoid that kind of catastrophe.
![]() |
![]() H363DS SQUARE D Non Fused Disconnect 100 Amp 600V 3P 4W US $600.00
|
![]() GE General Electric Non Fused Sz 0 Motor Starter US $600.00
|
![]() GE General Electric Sz 0 Combo Motor Starter Non Fused US $600.00
|
![]() ITE JU325 400 Amp 240 Volt Non Fused Disconnect US $400.00
|
![]() Westinghouse HU365 400 Amp 600 Volt Non Fused Disconnect US $400.00
|
![]() ITE Siemens NF354 200 Amp Non Fused Disconnect US $400.00
|
![]() GE TGN3323R 100a 240v non fused disconnect safety switch new N3R US $350.00
|
![]() Arrow Hart AU365 400 Amp 600 Volt Non Fused Disconnect US $350.00
|
| Powered by phpBay Pro |


US $1,999.99




















































































